200A Wind Turbine Charge Controller

1.Build In Rectifier
2.Build In Dump Load Controller
3.Build In High Wind Protection
4.12V/24V/36V Battery Auto-Sensing
Specification
This model controller is 12V/24V/36V Battery Auto-Sensing.
Battery Voltage
12V
24V
36V
Rated Charge Current
15A
7.5A
5A
Maximum Charge Voltage
14.4V
28.8V
43.2V
Dump Load Resistor
2 ohm/200W
8 ohm/200W
18 ohm/200W
High Wind Protection
Yes
(The controller will disconnect from wind turbine when wind Goes too high)
When the wind goes low, the controller will re-connect to turbine again)
Battery Reverse Protection
Yes
Short Circuit Protection
Yes
Overload Protection
Yes
Operating Temperature
-5°C -- 40°C
Control Method
PWM

When the Battery is connected to the Charge controller, the controller will detect the voltage of the battery first,
then it will decide how to charge the battery connected.