Sunday, August 7, 2011

LED light solar charger controller 12V 10A solar charger controller solar controller

Solar charge controller solar street light,Pulse Width Modulated Control,over-discharging control,protection against overload
Light+timer control
Solar charge controller for solar solar street lights
Control
: Micro Controller Unit utilizing dedicated software for precise control.

Charging mode:
Pulse Width Modulated control, allows for high efficiency boost, recovery and float charging. Temperature compensation ensures that these parameters are adjusted for maximum battery condition and hence, prolonged battery life.

High accuracy discharging control:
Over-discharging control voltage modified by the battery discharging rate curve.

Circuit protection:
protection against overload, short circuit and reverse connection,
Built in Transient Voltage Suppression protects against lightning. Reverse current leakage through PV
panel is blocked. Batteries are prevented from over-charging or discharging.

LED indication on system condition:
Indicating LED’s, monitor battery charging levels as well as battery state. LED monitoring of load conditions such as over load and short circuit as well as load on/off, are also provided.

Design standard:
Operating temperature range from -35 to +50 deg C.

No adjustable hardware:
C
ontroller accuracy, stability and reliability is assured by the use of flash memory for all control parameters and set-points.

Operation
: easy to operate, robust in design.

Output Modes
:
Constant Load (manual switched)….Normal.
PWM charge mode & State of charge (SOC)
Micro Controller Unit utilizing dedicated software for precise control.
Tempertature compesation
Fully automatic opertation & electric protections
Big terminals,easy to connect wire


T
E
C
H
N
I
C
AL

I
N
F
OR
M
A
T
I
ON
Note: All printed Voltages are only for 12V system. Double voltages for 24 Volt systems.
Regulation point 14.4 Volts (for 24v, use 2X)
Low voltage Disconnect 11.1V Volts (for 24v, use 2X)
Low voltage Reconnect 13.1 Volts (for 24v, use 2X)
Micro-controller digital accuracy
Type of Charging: Series, PWM & stat of charge (SOC)
4 Stages: equalization, PWM, Boost and Float, Temperature compensated charging.
Electronic protection includes overload, load short circuit and over current from solar panel.
Reverse polarity-solar, load, battery.
Reverse current through panels at night.
Limits high voltage to protect loads. Lighting protection.
Tropicalization Conformal coated printed circuit board
Terminals For wire sizes to 6mm²
Weights 250g
Dimension 140*90.5mm
Self-consumption 6mA maximum
Temperature 35 to 55 centigrade.
Enclosure IP22
Warranty 12 Months
Compliance CE,ISO9001


No comments:

Post a Comment